Why Use an SPDT Slide Switch for Altimeter Arming?
A single-pole double-throw (SPDT) slide switch is a common choice for arming an altimeter in high-power rockets. It gives you a simple, positive on/off control that you can reach through the airframe, so you can power up the electronics at the pad without disassembling the rocket. The key is choosing a switch that fits your build and wiring it so it stays reliable through flight.
What the SPDT Slide Switch Offers
- Single-Pole Double-Throw slide switch: Single-Pole Double-Throw slide switch, use for altimeter on/off. 5 amps @ 120 volts rating, 3 eyelet terminals for easy soldering; Fits in 1/4" x 1/2" hole in the airframe. This switch is rated for the low-current altimeter circuit and its compact size fits a small airframe hole, making it practical for high-power builds.

Single-Pole Double-Throw slide switch
Installing the Slide Switch in Your Airframe
Before you start, confirm the switch fits the hole you plan to cut. The switch is designed for a 1/4" x 1/2" opening, so measure your airframe location carefully. Use a drill and file to create a clean rectangular hole that matches those dimensions.
- Position the switch: Place the switch so the slide moves in a direction that is easy to reach and won't interfere with recovery gear or avionics. Mark the hole location on the airframe.
- Cut the mounting hole: Drill pilot holes at the corners, then file or cut the opening to 1/4" x 1/2". Test fit the switch before soldering.
- Solder the wires: The switch has 3 eyelet terminals for easy soldering. Connect the power lead from the battery to the common terminal and the altimeter positive lead to one of the throw terminals. Solder each joint securely and use heat shrink to avoid shorts.
- Mount the switch: Slide the switch into the hole and secure it with a small amount of epoxy or a retaining clip if your build allows. Make sure the slide moves freely.
- Test the circuit: With the altimeter connected, slide the switch to the ON position and confirm the altimeter powers up. Slide to OFF and verify it shuts down.
Wiring Considerations for High-Power Rockets
The SPDT switch is rated at 5 amps @ 120 volts, which is more than enough for the small current draw of a typical altimeter. The 3 terminals let you use one side for power and the other for a separate function, such as a continuity LED, but for simple arming you only need the common and one throw terminal.
Because the switch is exposed to the airframe, keep the wiring short and strain-relieved. Use a small service loop so vibration doesn't pull on the solder joints. Also, make sure the switch is oriented so that gravity or acceleration won't accidentally move the slide during boost.
What the Catalog Does Not Cover
The supplied information confirms the switch's rating, terminal style, and mounting hole size, but it does not include specific wiring diagrams or installation instructions for every altimeter model. You'll need to match the switch to your altimeter's power requirements and your airframe's layout. If you're unsure about the current draw of your electronics, check the altimeter's documentation before choosing a switch.


