What to Know Before You Cut
Working with carbon airframe tubing for high-power rockets is different from cutting phenolic or cardboard tubes. The 3.0" Carbon Airframe Tubing from High Power Model Rocketry is available in three series: Ultra Light (0.040" wall), Premium (0.056" wall), and Extreme (0.072" wall). Each series requires the same basic approach to cutting, but the thicker walls mean more time and care during the process.
All three series are made to order with a 3–5 week lead time, so plan your build accordingly. This tubing is available in 60" lengths, and you will need to cut it to your desired airframe sections.
Series Comparison at a Glance
- 3.0" Carbon Airframe Tubing: Ultra Light series has a wall thickness of 0.040" and is about the same weight as phenolic but stronger than Glass-Wrapped Phenolic Tubing. Ultra Light is ideal for competition rockets where low weight and high strength are top priorities. It allows you to fly a 4" diameter rocket to high altitudes using the same motors as a lighter build.

3.0" Carbon Airframe Tubing - 3.0" Carbon Airframe Tubing: Premium series has a wall thickness of 0.056" and is preferred for trans-sonic and super-sonic flight. If you plan to push your rocket past Mach 1, the Premium series offers the impact resistance needed for those speeds without excessive weight.
- 3.0" Carbon Airframe Tubing: Extreme series has a wall thickness of 0.072" and is described as 'crazy-strong' for record-breaking speeds and altitudes. For projects where leaving nothing to chance is the goal, the Extreme series provides maximum strength and durability.
Cutting and Preparation Steps
The following steps apply to all three series of the 3.0" Carbon Airframe Tubing. Always wear a respirator and eye protection when cutting carbon fiber.
- Measure and mark: Use a soft measuring tape or a wrap-around marking guide to mark your cut line. Wrap the tape around the tube to ensure a square cut. Use a fine-tip permanent marker or a scribe for the line.
- Choose your cutting tool: A fine-tooth carbide blade in a miter saw or a high-speed rotary tool with a diamond cut-off wheel works well. For thicker walls (Premium or Extreme), a slower feed rate prevents fraying.
- Cut slowly and steadily: Let the tool do the work. Pushing too hard can cause the carbon fibers to splinter or the tube to crack. Support both sides of the cut to reduce vibration.
- Clean the cut edge: Use a fine file or sandpaper (220 grit or higher) to remove any rough fibers. Wipe the edge with a damp cloth to remove dust. Do not blow dust off with compressed air—carbon dust is conductive and can damage electronics.
- Dry-fit before gluing: Test-fit the tube with your coupler, bulkhead, or motor mount before applying any adhesive. The Ultra Light series has a 0.040" wall, so ensure your coupler is sized for that inner diameter. A tight fit is normal; sand the inside of the tube lightly if needed.
Planning for the Lead Time
Because the 3.0" Carbon Airframe Tubing is made to order with a 3–5 week lead time, order your tubing early. If you are building a Level 3 rocket, consider the weight savings of the Ultra Light series: it allows you to fly on a much less expensive L or even K motor instead of a heavy M. The same logic applies to any high-power build—lighter airframes open up more motor options.
No matter which series you choose, the cutting and preparation process is straightforward. Take your time, use the right tools, and always dry-fit before committing to glue.


