Back to Blog
How-to Guides 2026-11-21 High Power Model Rocketry 0 views

How to Install a Decal Set Door Knob on Your Rocket

How to Install a Decal Set Door Knob on Your Rocket

Learn how to apply the Decal Set Door Knob to your high power rocket with professional results. Includes prep, application steps, and tips for a smooth finish.

What the Decal Set Door Knob Includes

The Decal Set Door Knob is a professionally printed vinyl decal set from LOC Precision, designed to give your rocket a high-impact, attention-grabbing look. The decals are made with premium cast vinyl and advanced adhesive technology, so they conform well to curved rocket body tubes and stay put once applied.

The set uses ECOSOL inks in CMYK mode, which produce a gloss finish with excellent white point and color saturation. According to the product information, these graphics are available at about half the price quoted from vinyl print shops, making them a cost-effective upgrade for your build.

Key Details About the Decal Set Door Knob

  • Decal Set Door Knob: Printed on premium cast vinyl with advanced adhesive technology for permanent graphic installation. Cast vinyl conforms well to rocket body curves and resists peeling during flight and handling.
    Decal Set Door Knob
    Decal Set Door Knob
  • Decal Set Door Knob: Uses environmentally safer ECOSOL inks in CMYK mode for high-impact, saturated graphics with a gloss finish. The inks produce vibrant colors that stand out on the launch pad and hold up to sun exposure.
  • Decal Set Door Knob: Manufactured in-house using advanced print/cut technology for precise shape matching. Each decal is cut to fit the intended area, reducing the need for trimming and improving alignment.

Step-by-Step Application Process

Follow these steps to install the Decal Set Door Knob on your rocket. Work in a clean, dust-free area with good lighting.

  1. Prepare the surface: Clean the rocket body tube with a mild detergent and water, then dry completely. Remove any oil or fingerprints. A smooth, clean surface helps the adhesive bond permanently.
  2. Dry-fit the decal: Place the decal on the rocket without removing the backing to check positioning. Mark alignment with a soft pencil or low-tack tape. This step prevents misalignment during final placement.
  3. Apply the decal: Peel a small section of the backing and align the decal using your marks. Slowly press the decal onto the surface while peeling the backing away. Use a squeegee or soft cloth to push out air bubbles from the center outward.
  4. Smooth and set: Once the decal is fully applied, rub firmly over the entire surface with a squeegee or your finger to ensure full adhesive contact. Pay extra attention to edges and curves.
  5. Allow to cure: Let the decal set according to the product instructions before handling the rocket or applying any clear coat. The adhesive reaches full strength over time.

Tips for a Smooth, Bubble-Free Finish

The premium cast vinyl used for the Decal Set Door Knob is designed to conform to curves without lifting, but careful application still matters. Work slowly and use a squeegee to push air out as you go. If a small bubble remains, you can prick it with a pin and smooth the vinyl flat.

For best results, apply decals at room temperature (around 70°F). Cold vinyl is less flexible and may not adhere as well. If your rocket has a textured or matte finish, test adhesion on a scrap area first.

Related Articles

Customer Service
Home
Products
Cart
Profile