Back to Blog
How-to Guides 2026-11-11 High Power Model Rocketry 7 views

Ariel Replacement Fin: Sizing and Installation Guide

Ariel Replacement Fin: Sizing and Installation Guide

Learn how to size and install the Ariel Replacement Fin for your PML rocket. This guide covers fit checks, prep, and bonding tips.

What the Ariel Replacement Fin Is

The Ariel Replacement Fin is a pre-cut G-10 fiberglass fin from PML, designed as a direct replacement for the Ariel kit. It saves you the trouble of cutting your own fins from raw material, but it still requires careful sizing and installation to fit your specific airframe.

Product Facts

  • Ariel Replacement Fin: This is a replacement fin for the Ariel kit. PML offers quality G-10 fibreglass fins pre-cut for your convenience, ready to be adapted into your latest project. Confirms the fin is pre-cut and made of G-10 fiberglass, but still needs adaptation — meaning you must verify fit and prepare the surface before bonding.
    Ariel Replacement Fin
    Ariel Replacement Fin

Sizing the Fin to Your Airframe

Before you apply any epoxy, check how the fin aligns with your rocket body tube. The fin is pre-cut but may need minor sanding to match the curvature of your airframe.

  1. Dry fit the fin: Place the fin against the tube where it will be mounted. Check for gaps along the root edge. A snug fit without rocking means less filler work later.
  2. Mark the root edge: Use a pencil to trace the fin's position on the tube. This gives you a reference for sanding and alignment.
  3. Sand the root edge: If the fin rocks or has a visible gap, sand the root edge lightly on a flat surface. Work slowly and recheck fit frequently. The goal is even contact along the entire edge.

Installation Steps

Once the fin fits well, follow these steps to bond it securely.

  1. Prepare surfaces: Scuff the bonding area on both the fin root and the tube with fine sandpaper. Wipe clean with isopropyl alcohol to remove dust and oils.
  2. Mix epoxy: Use a structural epoxy suitable for fiberglass. Mix according to the manufacturer's directions. Small batches are easier to work with and reduce waste.
  3. Apply epoxy: Spread a thin, even layer on the fin root and the corresponding area on the tube. Avoid excess that could squeeze out and create messy fillets.
  4. Position and clamp: Place the fin on the tube using your pencil marks as guides. Use tape or clamps to hold it in position until the epoxy cures. Check alignment with a square or ruler.
  5. Add fillets after cure: Once the initial bond is set, apply epoxy fillets along both sides of the fin root for added strength. Smooth with a gloved finger or a small tool.

What the Catalog Doesn't Tell You

The Ariel Replacement Fin is sold as a single fin, not a set. If you need multiple fins for a build, order the correct quantity. Also, because the fin is pre-cut but not shaped for a specific tube diameter, you may need to sand the root edge to match your airframe's curvature. This is normal and expected for a replacement part.

Related Articles

Customer Service
Home
Products
Cart
Profile