Back to Blog
How-to Guides 2026-11-20 High Power Model Rocketry 0 views

Applying the Decal Set Bruiser on Your Rocket

Applying the Decal Set Bruiser on Your Rocket

Learn how to apply the Decal Set Bruiser vinyl decals from LOC Precision. This guide covers surface prep, wet vs. dry application, and tips for a smooth, bubble-free finish.

Before You Start: What the Decal Set Bruiser Includes

The Decal Set Bruiser is a set of premium cast vinyl decals printed in-house by LOC Precision using ECOSOL inks. The vinyl has a gloss finish, excellent white point, and a conformable adhesive that allows permanent installation. The set is designed specifically for the Bruiser rocket, so the graphics are pre-sized to match the airframe.

Because the decals are printed on cast vinyl, they are thin and flexible, which helps them conform to curved surfaces without lifting. The adhesive is permanent, so placement needs to be correct the first time or corrected quickly before the bond sets.

Application Steps for a Smooth Finish

These steps assume you have a clean, dry rocket surface. Work in a dust-free area at room temperature.

  1. Clean the surface: Wipe the rocket body tube with isopropyl alcohol to remove oils, dust, and mold release. Let it dry completely before handling the decal.
  2. Cut out the decal: Use scissors or a craft knife to trim the decal close to the printed edge. Leave a small border of clear vinyl to make positioning easier.
  3. Choose wet or dry application: For large decals or curved surfaces, wet application gives you time to slide the decal into place. Mix a few drops of dish soap with water in a spray bottle. Lightly mist the rocket surface and the back of the decal. For small, flat areas, dry application works faster—just peel and stick.
  4. Position and squeegee: Place the decal on the wet surface and slide it into alignment. Use a squeegee or a credit card wrapped in a soft cloth to push out air and water from the center outward. Work slowly to avoid trapping bubbles.
  5. Let it cure: Allow the decal to dry and bond for at least several hours in a warm, dry place. Avoid handling or flying the rocket until the adhesive has fully set.

What the Catalog Confirms About the Decal Set Bruiser

  • Decal Set Bruiser: The decals are printed on premium cast vinyl with a conformable adhesive designed for permanent installation. This means the decals will stick firmly and follow curves without peeling, but you need to get the placement right on the first try.
    Decal Set Bruiser
    Decal Set Bruiser
  • Decal Set Bruiser: The graphics use ECOSOL inks in CMYK mode, producing a gloss finish with high impact and saturation. The colors are vibrant and the white point is strong, so the decals look good even on dark rocket bodies.
  • Decal Set Bruiser: These decals are available at about half the price quoted from vinyl print shops. You get professional-quality graphics without paying custom-shop prices, making it a cost-effective finishing option.

Tips for Avoiding Common Issues

Bubbles usually come from applying the decal too quickly or not using enough liquid. If a bubble appears after the decal is dry, you can prick it with a pin and gently press the air out.

Edges may lift if the rocket surface is not completely clean or if the decal is applied in cold conditions. Warm the decal with a hair dryer on low heat to soften the adhesive and press it down again.

The catalog does not specify a drying time, so allow at least overnight before handling. If you are in a humid environment, give it extra time.

Related Articles

Customer Service
Home
Products
Cart
Profile